29
English
Instal
lation Pr
oc
edur
e
Step 17 Setting the indoor unit option code
In order to set the indoor unit option code use the wired
remote controller and follow the directions below.
Main Menu Sub-menu
1 2 3
5
4
6
Data bit
1 2 3 4
5 6
Option Code
Page number
Option Code
SEG1
SEG2
SEG3
SEG4
SEG5
SEG6
0
Page number
SEG7
SEG8
SEG9
SEG10
SEG11
SEG12
1
Page number
SEG13
SEG14
SEG15
SEG16
SEG17
SEG18
2
Page number
SEG19
SEG20
SEG21
SEG22
SEG23
SEG24
3
Page number
1
Press the and
buttons at the same time for more
than 3 seconds and then a Main menu will be displayed.
2
Press the
/
button to select and then press
button to enter a Sub-menu setting screen.
3
Press the
/
button to select and then press
button to enter a Indoor unit option code setting screen.
NOTE
• The first digit represents the page number and the
remaining five digits are option codes.
• The option code which is currently setting will flicker.
4
Press the
/
button to set the option code in order.
Press
button to go to the next page.
5
Press the button to save and complete the option
setting.
6
Press the
button to exit to normal mode.
NOTE
• Press the
button anytime during setup to exit
without setting.
CAUTION
• Option code will not be applied if you don’t press the
• Setting indoor unit option code is only possible in Main
wired remote controller. You can only check the indoor
unit option code in Sub wired remote controller.
• Setting indoor unit option code is possible when one
indoor unit is connected. If more than 2 indoor units
are connected, you can only check the Main indoor unit
option code.
