Samsung 2 COLOR THERMAL PRINTER SRP-275, Operator'S Manual

Page: 50 / 111

5-29
ESC e
[Name] Print and reverse feed n lines
[Format] ASCII ESC e n
Hex 1B 65 n
Decimal 27 101 n
[Range] 0
≤
n
≤
1
[Default] None
[Description] Prints the data in the print buffer and feeds n lines in the reverse direction.
[Notes] The amount of paper fed per line is based on the value set using the
line spacing command (ESC 2 or ESC 3).
After printing, the printing position moves to the beginning of the line.
This command is used to temporarily feed a specific line without changing
the line spacing set by other commands.
This command must not be executed consecutively more than one time.
In the reverse direction, the maximum paper feed amount is 4.23 mm
(24/144 inch). If the specified amount exceeds 4.23 mm (24/144 inch),
the printer only prints the data and does not feed the paper.
ESC i
[Name] Partial cut (one point left uncut)
[Format] ASCII ESC i
Hex 1B 69
Decimal 27 105
[Range] None
[Default] None
[Description] Executes a partial cut of the paper roll with one point left uncut.
5-28
ESC c 5
[Name] Enable/disable panel buttons
[Format] ASCII ESC c 5 n
Hex 1B 63 35 n
Decimal 27 99 53 n
[Range] 0
≤
n
≤
255
[Default] n = 0
[Description] Enables or disables the panel buttons.
- When the LSB of n is 0, all buttons are enabled.
- When the LSB of n is 1, all buttons are disabled.
[Notes] If panel buttons are disabled, the function of the panel button,
such as feeding, will be executed when the panel button is turned on.
To prevent problems caused by accidentally pressing the buttons,
use this command to disable the buttons.
ESC d
[Name] Print and feed n lines
[Format] ASCII ESC d n
Hex 1B 64 n
Decimal 27 100 n
[Range] 0
≤
n
≤
255
[Default] None
[Description] Prints the data in the print buffer and feeds n lines.
[Notes] The amount of paper feed per line is based on the value set using the line
spacing command (ESC 2 or ESC 3).
After printing, the printing position moves to the beginning of the line.
This command is used to temporarily feed a specific line without changing
the line spacing set by other commands.
CONTROL COMMANDS LIST
CHAPTER 5