ENGLISH
For Slim 1 Way cassette
Connect the cables between the indoor unit and the panel.
4-1
Remove the 3 screws of the electrical component box and take out
the electrical component box cover.
4-2
Connect the panel connector to the indoor unit PCB connector.
Connect the swing motor of the panel or the connectors of
remote controller sensor to each connector of the indoor unit.
Make sure the colors of the connector match.
4-3
Reassemble the electrical component box.
4-4
Close the filter.
4
If the connector is disconnected or the color of the cables is mixed
up, the air conditioner and the remote control will not operate.
Motor
connector for
driving grille
5
Check if the panel is firmly fixed to the indoor unit.
5-1
When tightening the screws, make sure that there is no gap between
the panel and the ceiling and the panel should be parallel with the
ceiling or ceiling joint.
If the panel is installed incorrectly, air may leak.
When there is a gap between the panel and the ceiling, adjust the
height of the indoor unit.
5-2
Check the installation again as incomplete installation might
cause the problems below.
If the gap between the panel and the indoor unit is over 15mm,
air may leak or condensing water may come out. Therefore, the
15mm distance between the panel and the indoor unit should be
maintained by using a vertical gauge (pattern sheet).
Air leak
Dirts
Dew
5
Make sure that there is no gap here.
Make sure that there is no gap here.
NOTE
NOTE
Connect the grille.
6-1
Hook the grille by putting the hinge part into the groove, fit the
3 link parts as shown in the picture and then pull them down to
connect.
※
Caution when detaching the panel.
When detaching the panel, grip the link part where the panel and
intake panel are connected (
❶
) and push up the link at the panel
part (
❷
) to disconnect as shown in the picture(1).
When power supply malfunctions, detach the panel by using a
driver at the marked point (2) and proceed with the same method
as shown in the picture(1) to detach the panel and then check the
power connection status.
6
Before installing the grille, you should connect the safety clips to
each side of the grille in order to prevent the grille from dropping.
NOTE
NOTE
(2)
(1)
❶
❷
NASA_PANEL_IM_EN_03683A(1).indd 5
2013-01-14 오후 8:35:34
