Samson 5827, Mounting And Operating Instructions, Page: 30 / 92

5-6 EB 5827-2 EN
Installation
5.6 Electrical connection
Risk of fatal injury due to electric shock.
Î
Upon installation of the electric cables,
you are required to observe the regula-
tions concerning low-voltage installations
according to DIN VDE 0100 as well as
the regulations of your local power sup-
plier.
Î
Use a suitable voltage supply which
guarantees that no dangerous voltages
reach the device in normal operation or
in the event of a fault in the system or
any other system parts.
Î
Only perform the electrical connection
after switching off the supply voltage.
Make sure the supply voltage cannot be
switched on again unintentionally.
Î
Use plastic cable glands with cable grip
at the cable entry.
Risk of actuator damage due to incorrect
wiring of the inputs.
Î
Wire the inputs range according to the
technical data (see the 'Design and prin-
ciple of operation' section).
Wiring
Î
Connect the wiring as shown in Fig. 5-5 .
Risk of actuator damage due to a short cir-
cuit.
The supply voltage as well as the input and
output signals are not galvanically isolated
from one another.
Î
Do not apply any external voltage.
Î
Do not connect terminals with each other.
Î
Make sure that the single wires of multi-
wire cables do not touch neighboring
terminals.
DANGER !
NOTICE !
NOTICE
!