Samson 3241, Mounting And Operating Instructions

Page: 24 / 64

24 EB 8012 EN
Preparation
4 Preparation
After receiving the shipment, proceed as fol-
lows:
1. Check the scope of delivery. Compare
the shipment received against the deliv-
ery note.
2. Check the shipment for transportation
damage. Report any damage to
SAMSON and the forwarding agent (re-
fer to delivery note).
4.1 Unpacking
Note:
Do not remove the packaging until
immediately before installing the
valve into the pipeline.
Proceed as follows to lift and install the
valve:
1. Remove the packaging from the valve.
2. Dispose of the packaging in accordance
with the valid regulations.
NOTICE
Risk of valve damage due to foreign
particles entering the valve.
The protective caps fitted on the
valve's inlet and outlet prevent for-
eign particles from entering the valve
and damaging it.
Do not remove the protective caps
until immediately before installing the
valve into the pipeline.
4.2 Transporting and lifting
DANGER!
Hazard due to suspended loads fall-
ing.
Stay clear of suspended or moving
loads.
WARNING!
Risk of lifting equipment tipping and
risk of damage to lifting accessories
due to exceeding the rated lifting ca-
pacity.
−
Only use approved lifting equip -
ment and accessories whose mini-
mum lifting capacity is higher than
the weight of the valve (including
actuator, if applicable).
−
Refer to section 3.3 or Data Sheet
u
T 8012 for weights.
WARNING!
Risk of personal injury due to control
valve tipping.
− Observe the valve's center of gravi -
ty.
− Secure the valve against tipping
over or turning.
