12
EB 3135-1 EN
Safety instructions and measures
1.3
Notes on possible property damage
NOTICE
!
Malfunction due to a configuration that does not meet the requirements of the appli
-
cation.
The electric actuator with process controller is configured for the specific application by
setting configuration items and parameters.
Î
Perform the configuration for the specific application during start-up and after a re
-
set to default settings.
Manipulation of settings at the electric actuator with process controller due to unau
-
thorized access.
The electric actuator with process controller has a communication interface for data
transmission with the TROVIS-VIEW software (firmware 1.1x: Bluetooth
®
, firm
-
ware 2.1x: Modbus RTU). The communication interface is active in the delivered state
of the electric actuator with process controller.
Î
When data transmission is not used, deactivate the communication interface with
the operating keys or by setting the 'Protocol' parameter to 'None'.
Risk of damage to the screw heads on the front housing cover due to the use of the
wrong tool.
The front housing cover of the electric actuator is fastened using TORX PLUS
®
screws,
size 10IP.
Î
To loosen and tighten the screws, only use the following screwdrivers:
−
TORX
®
T10
−
TORX PLUS
®
10IP
−
Flat-blade screwdriver with 0.8 mm blade thickness and 4.0 mm blade width
SAMSON's After-sales Service can support you concerning lubricant, tightening
torques and tools approved by SAMSON.
Note
