1 mm
36
38
42
24
25
20
26
42
40
39
32
33
34
35
42
37
Adjust the bush and the counter-nut so that
the rod (42) pushes out about 1 mm from the
counter-nut
(see figure).
• Check the conditions of the sealing ring inside the
motor support (
39
).
• Verify the conditions and exact position of the gasket (
40
).
• Spread a thin layer of Vaseline grease on the inner walls
of the cylinder (
38
).
• Very carefully insert the piston rod (
42
) in the cylinder (
38
).
• Fasten the cylinder (
38
) on the support (
39
)
(comply
with positioning)
and simultaneously insert the motor
rod in the support.
• Position the washers (
37
) and tighten the screws (
36
) .
• Insert the washer (
35
)
on the motor rod (
42
).
• Very carefully insert the rod guide screw on the motor
rod (
34
)
(having it slowly turn following the direction
of the rod threading)
and tighten it.
• Insert the shock absorber (
33
) and the washer (
32
).
• Tighten the bush (
26
) on the motor rod (
42
), insert the
housing (
20
), the washer (
25
) and tighten the counter-
nut (
24
).
Check the seal ring
NOVA 10:1
19
ED.
01 - 09/2023 - Cod. 150209
IT
EN
Fig. 11
Fig. 12
