www.larius.com
8
VIKING
ED. 03 - 09/2020 - Cod. 150163
Absolutely avoid to spray solvents indoors. In
addition, it is recommended to keep away from
the pump in order to avoid the contact between
the solvent fumes and the electric motor.
Make sure the product to be used is compatible
with the materials employed for manufacturing
the equipment
(stainless steel and aluminium).
Because of that, please contact the supplier of
the product.
PREPARATION OF THE PAINT
• Make sure the product is suitable to be used with a spray
gun.
• Mix and filter the product before using it. For filtration, use
CLOSE-MESH
(ref.214)
and
LARGE-MESH
(ref.215)
LARIUS
METEX
braids.
• Point the gun at a container keeping the trigger pressed
(so
as to drain the oil inside)
till a clean solvent comes out. Now,
release the trigger.
• Remove the suction pipe and take away the solvent tank.
• Point the gun at the solvent tank and press the trigger so as
to recover the residual solvent.
• As the pump idles, press the
ON/OFF
switch
(H6)
su
OFF
(0)
on the position
"OFF" (0)
to stop the tooling.
WORKING
START OF THE PAINTING OPERATIONS
• Use the tooling after performing all the
SETTING UP
operations above described.
• Dip the suction pipe
(I1)
into the product tank.
• Open the re-circulation valve
(I2)
.
• Press the
ON/OFF
switch of the equipment and turn a little
the pressure control knob
(I3)
clockwise, so as the machine
works at the idle speed.
• Now the machine is ready. Should you use water paints,
besides the solvent wash, a wash with soapy and then clean
water is suggested.
• Insert the gun trigger lock and assemble the nozzle.
Never use products containing halogen hydrocarbons
(as
methylene chloride)
. If these products come into contact with
aluminium parts of the equipment, can provoke dangerous
chemical reactions with risk of explosion.
• Make sure the product recycles from the return tube
(I4)
.
• Close the re-circulation valve.
• At this point the machine will continue to suck the paint
product until the delivery hose is completely full. Afterwards,
the product will re-circulate automatically.
I1
I3
I4
I4
I1
I3
I2
I
Fig. 1I
