www.larius.com
11
PNEUMATIC HOIST 200
ED. 01 - 10/2019 - Cod. 150097
G
H
I
A1
USE CORRECT
ATTENTION
Make sure there is sufficient space in height when
the hoist is in the highest position.
During operation of the pump can create conditions
of electrostatic energy.
• before using the pump you must provide for the
grounding connection.
• the pump is equipped with a special terminal and
its grounding wire (A1).
The single column pneumatic extrusion ram is suitable for oper
-
ations with 200-litre drums.
• The stem must be correctly positioned between the two
columns and securely attached to the base plate using the
clamps.
• The stem must not be deformed or damaged.
• The pumps installed on the hoist are piston and are suitable
for pumping highly viscous products (
up to 2 million cps
).
• Use products that are chemically compatible with the pump
parts that are in contact with the product to be pumped.
Contact the manufacturer before using products other than
those provided for in the contract of sale.
• The pressure of the compressed air supply must be between
3 ÷ 6 bar.
NOTE
Any other use of the equipment not provided for in the contract of sale
is declared improper.
GROUNDING
SETTING-UP
The operator will have to arrange an environment suitable to the
plant before installing as indicated here below:
•
An area wide enough to allow the drum loading an unloading
and routine maintenance operatiions.
•
Ensure there is a sufficient space in height to enable the
ram lifting and an easy access to the air regulation groups.
•
For the pneumatic ram feeding, use a tube with an internal
diameter no lower than 10 mm
Install a condensate filter and a shut-off valve
type ON-OFF on the air supply line to the ram.
•
Make sure the air governors to the pump and ram are closed
(
turn counterclockwise the control knob to close them
)
•
Make sure the air delivery valve to the shovel plate is closed.
•
Make sure the air delivery pipe to the pneumatic pump is
connected to the ram and to the pump.
•
Make sure the air delivery pipe to the shovel plate is connected
to the ram and to the shovel plate.
WORKING
Check all the fittings for the connection of the
different components (
pump, flexible hose,
gun, etc..
) before using the equipment.
Avoid approaching too much to the ram during
the ascent and descent functions.
•
Open the air supply to the ram.
Fig. 8
