www.larius.com
18
GIOTTO LINER PLUS
ED. 03 - 08/2020 - Cod. 150160
J3
J3
J4
J1
J2
J5
J6
Recirculating-safety valve: when working at the
maximum pressure available, releasing the gun
trigger sudden increases of pressure can occur.
In this case, the recirculating-safety valve opens
automatically eliminating part of the product from
the recirculating tube.
Then it closes so as to go back to the first working
conditions.
• Release the residual pressure by holding down the trigger
of the gun and pointing it into a container.
• Eliminate the paint remaining within the tank (
J2
) by placing
the re-circulation tube (
J3
) into a container.
•
Open the recirculating-safety valve (
J4
).
Follow the washing procedure before using again
the equipment.
• Empty all of the wash fluid from the tank and turn off the
equipment.
•
Turn the pressure adjustment handle (
J1
) to minimum
(pump
stopped).
• Shut off the motor.
• In case of long storage, we recommend you to suck and
to leave light mineral oil inside the pumping group and the
flexible hose.
•
Turn the pressure adjustment (
J1
) handle slightly clockwise
to make the machine function at minimum pressure
(pump
activated)
, until the tank has been completely emptied then
shut off the pump by bringing the handle (
J1
) to its minimum
position.
• Fill the tank (
J2
) with wash fluid.
•
Clean the walls of the tank with a brush.
•
Turn the pressure adjustment (
J1
) handle slightly clockwise
to make the machine function at minimum pressure
(pump
activated).
• Make sure the re-circulation tube
(
J3
) is inserted into a
container and wait for clean wash fluid to come out of it.
•
Turn the pressure adjustment handle (
J1
) to minimum
(pump
stopped).
• Place the re-circulation tube back into the tank.
• Keep the gun’s trigger pressed to release any residual
pressure.
• Remove the nozzle from the gun and wash it separately.
•
Closed the recirculating-safety valve
•
Turn the pressure adjustment handle (
J1
) slightly clockwise
to make the machine function at minimum pressure
(pump
activated).
•
Point the manual gun (
J5
) into a container (
J6
), drain the
residual paint and wait for the wash fluid to come out clean
the entire spraying circuit.
J
CLEANING AT THE END OF WORK
• Reduce pressure to the minimum
(turn counterclockwise the
pressure control knob (
J1
) ).
