Larius 2 - painting
www.larius.com
12
ED.
14 - 11/2021 - Cod. 150145
PREPARATION OF THE PAINT
• make sure the product is suitable to be used with a spray
gun.
• mix and filter the product before using it.
Make sure the product to be used is compatible
with the materials employed for manufacturing
the equipment (
stainless steel, aluminium and
carbon steel
). Because of that, please contact
the supplier of the product.
never use products containing halogen hydrocarbons (
as
methylene chloride
). If these products come into contact with
aluminium parts of the equipment, can provoke dangerous
chemical reactions with risk of explosion.
• point the gun at a container keeping the trigger pressed
(
so as to drain the oil inside
) till a clean solvent comes out.
now, release the trigger.
• point the gun at the solvent tank and press the trigger so
as to recover the residual solvent.
• Close the pressure setting knob (
G3
).
Do not set the pump to work without product,
because this could spoil its gaskets.
Absolutely avoid to spray solvents indoors. In
addition, it is recommended to keep away from
the pump in order to avoid the contact with the
solvent fumes.
• now the machine is ready. should you use water paints,
besides the solvent wash, a wash with soapy and then
clean water is suggested.
WASHING OF THE NEW EQUIPMENT
• The equipment has already been adjusted at our factory
with light mineral oil left inside the pumping group as
protection. As soon as the connections have been carried
out, before putting the product in the tank, it is necessary
to rinse the pump by means of the circulation of solvent
(thinner for paints).
• Clean hoses (
G1
) and (
G2
) by blowing compressed air
before connecting them
•
make sure that the atomising air supply is shut off.
• rotate the pressure setting knob (
G3
) slightly clockwise
so that the machine operates at minimum power.
G1
G3
G2