Larius 2 - painting
www.larius.com
16
ED.
14 - 11/2021 - Cod. 150145
TROUBLESHOOTING
Solution
Cause
Problem
•
The equipment does not suck the
product
•
The equipment suck but does not
reach the pressure desired
•
When pressing the trigger, the
pressure lowers considerably
•
The pressure is normal but the
product is not atomized.
•
Leakage from the seal-tightening
screw
•
The atomization is imperfect
• suction filter clogged;
• suction filter too fine;
• The equipment sucks air;
• lack of product;
• The equipment sucks air;
•
The circulation tap is open;
• nozzle too big or worn;
• The product is too dense;
• The nozzle is partially clogged;
•
There is no atomising air;
• The product is too dense;
• gasket worn or needs adjustment;
• The nozzle is worn;
• Clean or replace it;
• replace it with a larger-mesh filter
(
with very dense products, remove
the filter
);
• Check the suction pipe;
• add the product;
• Check the suction pipe;
• Close the circulation tap;
• replace it with a smaller one;
• dilute the product, if possible;
• Clean or replace it;
• Check the flow regulator for the
atomising air;
• dilute the product, if possible;
•
Replace or adjust the gasket;
• replace it;
K
