Samlex Europe WSC-1215, Manual

Page: 26 / 31

26
9 Using the Charger
ENG
"E.Q." LED "STATUS" LED Status
Red, constantly lit I phase
Orange, constantly lit Uo phase
Green, constantly lit U phase
Red, constantly lit Red, constantly lit I phase, Equalization is acti-
vated
Red, constantly lit Orange, constantly lit Uo phase, Equalization is
activated
Red, constantly lit Green, constantly lit U phase, Equalization is
activated
Red, constantly lit Equalization is executed
Red, flashing I phase, half power
Orange, flashing Uo phase, half power
Green, flashing U phase, half power
Green, double flashing Power supply mode
Red, slowly flashing Stand-by mode (RC-600)
10 Trouble Shootings
10.1 The battery voltage would NOT increase after charging
• If possible, measure with a suitable multi-meter during the charging to verify if the voltage at the
battery terminals increases.
• Determine whether the terminals are connected properly to the battery poles. Clean the battery poles
if necessary to ensure better connection.
10.2 The battery is NOT fully charged after a charging time about 20 hours
• Disconnect the power to the charger.
• Remove the battery from the charging terminals and wait for a few minutes.
Then, measure the voltage at the battery terminals with the multi-meter.
Table 9-2 Normal Functional Check Table