23
RC-600 buttons
Charger working mode
Half power
Equalization
Others
Power Supply
"HALF POWER"
pressed
Exit "HALF
POWER"
("STATUS" LED
lights)
VOID
Enter "HALF
POWER"
("STATUS" LED
flashing)
VOID
S3 "E.Q." pushed
VOID
VOID
Equalization
("E.Q." LED
lights Red)
VOID
"ON/OFF" pressed
Stand by
("STATUS" LED
slowly flashing
Red)
Stand by
("STATUS" LED
slowly flashing
Red)
Stand by
("STATUS" LED
slowly flashing
Red)
Stand by
("STATUS" LED
slowly flashing
Red)
9
Using the Charger
ENG
Table 9-1 VOID Setting table for pressing button on remote controller
Note
• The power switch at the unit must be switched ON, so that the unit can be switched ON and OFF
with the remote control.
• The "ON/OFF" button on the RC-600 should be pressed for 2 seconds to switch OFF the battery
charger, and 0.5 second to turn ON.
9.3 Units with Temperature Sensor TF-100
A temperature sensor (Figure 12 Temperature Sensor TF-100, Page. 7) can be connected in
order to provide the optimum charging functioning. The charging voltages, as can be seen
from the following diagrams, vary, depending on the battery temperature.
Summary of Contents for WSC-1215
