22
9
Using the Charger
ENG
9.1.5 Equalization
The function of equalization could be activated as long as the battery charger is NOT in the
half power mode or power supply mode.
The function of equalization will be activated only when the battery is charged and stays in
Uo phase with < 25% of Full load current.
The battery charger will charge the battery 3 hours with equalization setting voltage (15.5V
or Uo phase setting voltage) and half of rated current.
Note
Once the equalization function is activated, it can only be cancelled by turning off the battery charger.
Note
The battery chargers WSC-1215 and WSC-1230 have an option to have a 2A charging output for the
starter battery (WSC-1215SB, WSC-1230SB). The output voltage is 13.8V and can recharge the starter
battery with a current of 2A or keep it at a high capacity level.
9.2 Using the remote controller RC-600
There are three buttons and four LEDs on RC-600 (see Figure 13 Remote Controller RC-600,
Page. 8).
• ON/OFF button to switch the charger ON and OFF
• Half Power button to enter/exit "HALF POWER" mode
• Equalization button to activate the function of equalization
• Bulk LED to indicate the charging stage of I phase
• Absorption LED to indicate the charging stage of Uo phase
• Floating LED to indicate the charging stage of U phase
• Equalization LED to indicate the function of equalization is activated
To avoid the VOID setting from the remote control, please refer to Table 9-1 VOID Setting.
Summary of Contents for WSC-1215
