SAMES KREMLIN
- 2 -
N° : 578.188.110-UK-1802
Before removing a component of the gun, some precautions have to be respected :
-
Empty out the paint inside the cup or the receiver.
-
Fill the cup or the receiver with cleaning solvent.
-
Decrease the supply air pressure of the gun.
-
Spray the solvent until it runs clear.
-
Shut off the supply air pressure of the gun.
-
Shut off the material pressure.
-
Trigger the gun to depressurize the circuit.
-
Empty out the solvent when using a gravity cup.
-
Remove the part to be cleaned or changed.
Before reassemblying the different components, some precautions must be taken :
-
Clean all the parts with the appropriate cleaning solvent and a brush.
-
Install new seals if it is necessary after having lubricated them with PTFE grease.
-
Install new parts if it is necessary.
PISTON PACKING (18)
Unscrew cylinder (23) - (take care not to damage the spring 22).
Take hold of the entire needle and piston assembly (10 and 16) and pull them towards the back.
Unscrew nut (21). Remove support washer (20) as well as packing (18).
Clean the parts and change them if necessary.
When reinstalling :
Before inserting piston (17), the packing lip (18) must be shaped by hand as shown opposite.
Glue nut (21) on piston (17) with Low strength - Aneorobic Adhesive - Loctite 222. Change seal (19).
23
10
22
20
21
17
19
18
16