SAMES KREMLIN 64350225130000, User Manual, Page: 195 / 238

Operations Dismantling / Reassembling the C225 Fluid section
582108110-EN-indG-Pompe Azur-52C225.docx
195
In case of replacement of the pin
Replace the pin with a new one, holding it with a mallet.
Depending on the viscosity of the product and if the
lifting of the ball is greater:
o
Replace the pin L=30 mm with pin L=28 mm or
L=24 mm depending on the viscosity of the
product (spare part).
Material type Suction positioner Exhaust pin size Comment
Liquid material Top position L24 or L28 pin Longer travel possible to empower the
suction
Viscous material Bottom position L30 Pin Avoid the ball to lift too much to shorter
the closing time due to viscosity
Each pump are mounted as follow from
the factory
In the event of a discharge valve + ball change
Tip: It is recommended to change both at the same time
Position the piston in the jaws of the vise at the flats of the
discharge valve.
With a flat wrench
Unscrew the discharge valve at the flat part of the piston
fitted.
Unscrew the discharge valve of the piston, resting on the
two flats.
Loosen the vice and recover the ball 8+ the discharge
valve.
Change the two pieces.