Operator's Manual
Round bale wrapper
Spin S, Spin F
- 32 -
9.
REGULAR INSPECTION
9.1.
User inspection
After every use of the wrapping machine, check:
The conditio and legibility of the data plate and symbols,
Condition of the drawbar,
Hydraulic system leakproofness,
Drive chain of the rotary frame,
Drive chains of the rotary drums.
The nameplate must only be replaced a tan authorised repair shop.
Replace the unintelligible symbols with new ones.
After the working season is over, grease the drive chain of the rotary frame and the drive chains
of the rotary drums using the LT-43 grease.
Send the counter to an authorised service if the casing is damaged. Any attempt to repair the
damaged counter will result in the warranty becoming null and void.
Repalce the oil of the intersecting axis gear every two year as follows:
Place the machine on a level surface,
Place a leakproof tank below the drain plug,
Remove the drain plug, the filler plug and the overflow plug,
After the oil is drained, close the drain plug,
Pour fresh 80W90 hydraulic gear oil to the filler plug level,
Close the filler plug and overflow plug.
The used oil should be sent to a gas station which collects such products.
IMPORTANT:
During oil replacement, it is required to wear impermeable protective
clothing suitable for contact with oil-based products.
Replace the hydraulic lines every 5 years. Before every working season, check (without a
silage bale loaded) the operation of the transmission system by turning on the rotary table, raising
and lowering the rotary table and raising and lowering the loading arm.
9.2.
Service checks
Periodical service checks shall be perfomed after every two working seasons of machine
use.
It is advised to use original replecement parts which will help maintain the wrapping
machine in good technical condition for a long time.