Operator's Manual
Truck Snow Plow
SnowPick
-
14
-
To mount the plow on the vehicle do the following:
lift the hitch on a required assembling height using support foot (if no range is available (Fig.
11) place mounting point for foot bolt in the other hole (Fig. 10), and set hitch fins (Fig. 7 – A)
so they are vertical in relation to the ground using chain (Fig. 8 – C),
Fig. 9. Shield inclination adjustment
(A –
Linkage frame, B – Adjustment bolts, C –
Rotation axle)
Fig. 10. Adjusting support foot height
drive the vehicle towards the plow at a distance allowing for mounting,
after mounting the plow insert two pins C and secure them with cotters D (Fig. 7),
fold support foot A and secure it with cotter (Fig. 8),
set rotation axle B of the shield perpendicular to the ground (Fig. 8), then adjust by loosening bolt
connection B (Fig. 9
Fig. 9
), next tighten the bolt connection with torque 92lbf*ft (125Nm) (Important: Adjustment
should be carried out on a flat surface after lowering the shield),
connect the wiring system,
connect control panel to wire harness block,
check lighting for proper operation,
adjust height of toppings D,
lift the shield to its maximum and check the gap between bumpers (min. 6 mm – ¼") Fig. 12, if
the gap is smaller than the one given adjust the chain accordingly,
check basic functions (UP/DOWN/RIGHT/LEFT).
Fig. 11. Range of SnowPick plow hitch height adjustment
Increasing
hitch height
