Instrukcja obsługi
Operator's manual
Lightweight, rear disc mowers
SAMBA
- 31 -
7.
LUBRICATING
7.1. Risks present when lubricating
❑
If risk of splashing is present, make sure to wear protective eyewear with side guards.
❑
When lubricating protect eyes and skin against contact with the substance. Therefore use adequate
protective wear with long sleeves and protective footwear. Also use protective gloves. In case of
a contact with skin, immediately wash the infected area with plenty of water with soap.
❑
Do not allow the product to contaminate water outlets, water courses and soils.
❑
In case of an unintentional release to the environment plug the leak, limit the spillage, and then
collect the oil with non-flammable absorbent material (e.g. sand).
❑
The product is flammable. In case of fire, use adequate fire-extinguishing means (e.g. foam, water
mist, extinguishing powders). Do not use water jets.
❑
Disposal of the used product must be made according to official regulations. Improper disposal of
the used oil poses danger to the environment.
7.2. Cutter bar
Cutter bar is filled with oil through plug closed hole (
A
)
). Adequate oil level with
horizontal position of the cutter bar is
5÷7 mm from the cutter
bar's bottom. To drain the oil use plug
(
B
) (
), found in lower section of the cutter bar. The best time to drain oil is immediately after
operation, if still warm.
Fig. 26.
Points of oil inspection and replacement in cutter bar
Tab. 5.
Amount of oil to be filled in cutter bar
Mower type
Oil volume [l]
Oil type
Replacement frequency
SAMBA 160
1.2
SAE 90 EP
(ISO VG 320)
After first 50 h of operation, then after next 500 h
(or at least once a year)
SAMBA 200
1.5
SAMBA 240
1.8
SAMBA 280
2.1
SAMBA 320
2.4
7.3. Intersecting axis gear
On daily basis prior to work commencement check the oil level and, if needed, refill once
removing the vent (
A
) (
) in upper section of the gear. Oil level is inspected by opening check
plug (
B
). If the oil level is too low refill the oil until it is visible in the check opening (
B
). Oil level in
gear: approx. 0.7 l. Oil level is checked after the cutter bar is set horizontally on the ground.
a)
b)
A
B
