SaMASZ NANO 150, Operator'S Manual, Page: 9 / 32

Operator’s manual
Front flail mowers
NANO 150, NANO 150 H
- 7 -
Tab. 3. Flail knives applicable in NANO flail mowers
Flail knives
STANDARD OPTION
Flail knife type VII Flail knife type VIII Flail knife type X
Width: 68 mm
Length: 73 mm
Mass: ∼ 0,2 kg
Width: 84 mm (2x42 mm)
Length: 82 mm
Mass: ∼ 0,3 kg
Width: 62 mm
Length: 62 mm
Mass: ∼ 0,3 kg
Application:
grass, stalks
Application:
grass, stalks, shrubs, shoots, thin
branches
Application:
grass, stalks, shrubs, shoots, thin
branches
WARNING!
Before operating make sure whether mounting direction of knives is correct
(
Fig. 16
).
If found, replace any damaged or worn knives. In case of replacing cutting knives, they should
have the same weight. Admissible difference in weight should not be more than 3 g. If a single
knife requires to be replaced, the opposite one should also be replaced in order to prevent improper
balance.
4. SAFETY ADVICE AND WARNING
4.1. Safety rules and regulations

Rear axis of the vehicle should be well weighted to keep the balance. If need be, use rear wheel
weights.

The mower cannot be used if the vehicle has not been properly balanced.

When mounting the mower on the vehicle be aware of the risk of wounding. The operator
should wear protective gloves.

Any operation with the hydraulic lift lever should be conducted from the operator's seat; DO
NOT move the lever from outside of the vehicle.

In case of vehicles equipped with EHR, controlling with hydraulic lift is conducted with a
button located outside the vehicle's cabin. When operating, please be extremely careful.

Operating with damaged or worn guards is not permitted.

No unauthorized personnel is allowed to remain within the danger area of at least 50 m. Keep
particular caution when operating near roads (danger of throwing out of hard elements).

Any maintenance and adjustment work is allowed only with the drive disconnected and the flail
shaft in complete standstill.