3 Installation and Operation
3-8
SAM4S ER-5200 Series
3-3 Operation
3-3-7 Self Test
3-3-7-(a) Test Printer
1. Turn the Mode key marked ‘
C
’ to Service Mode position.
1. Press ‘
1’, ‘0’
and
‘SBTL’
key on key board.
2. Then the printer prints the test pattern. The printing message shows some information sush as ‘TM value’,’stbIdx
(Strobe index)’.
3. After printing, The drawer is opened. Then the printer test is finished.
3-3-7-(b) Test Display
1. Press ‘
1’, ‘1’
and
‘SBTL’
key on key board.
2. Then the buzzer will work for 1 sec.
3. After testing the buzzer, Some characters are displayed on the rear VFD display
3-3-7-(c) Test Key Board
1. Press
Press ‘
1’, ‘2’
and
‘SBTL’
key on key board.
2. Press any key you want on the key board.
3. The key code of pressed key will be showed on the VFD.
4. Turn the mode key to any position to finish this test.
3-3-7-(d) Test Mode Key
1. Press
Press ‘
1’, ‘3’
and
‘SBTL’
key on key board.
2. Turn the mode key to any position.
3. The corresponding Mode name will be showed on the VFD.
3-3-7-(e) Test RS232C
1. Install the serial loop back test jig. (Short pin 2 and pin 3 of DSUB connector)
2. Press
Press ‘
1’, ‘4’
and
‘SBTL’
key on key board.
3. If error occurs, the message (232 NOGOOD) is displayed on VFD and the Buzzer beep. Then Press
“Clear”
key.
Note :
When the ports is no connection or the cable is open, the Error occur.
3-3-7-(f) Test IRC
1. Install the serial loop back test jig.
2. Press
Press ‘
1’, ‘4’
and
‘SBTL’
key on key board.
3. If error occurs, the message (IRC NOGOOD) is displayed on VFD and the Buzzer beep. Then Press
“Clear”
key.
Downloaded from
www.Manualslib.com
manuals search engine
