28.
If the device is no longer needed keep it in a safe place.
29.
Never undertake any repair or do-it-yourself work – even if very simple things yourself.
Start-Up:
Our grain mill AM 3 mill has to be connected to an earthed power source with a 380 V power current
with a frequency of 50 Hz.
Important for connection to power current source:
A European Standard plug with integrated over-current cut-out switch was chosen as plug connector.
The mill-stones must rotate in a clockwise direction (right hand motion).
Left hand rotation requires
the conductors R (L1) and T (L3) which supply the cut-out switch to be changed over.
Adjustment of the Milling Grade:
The hand wheel on the side of the mill adjusts the setting of the mill. The adjustment mechanism is
extremely sensitive and allows step-free setting of the degree of refinement required within a range
of approx. 3,5 turns.
Basic Setting: Turning the hand wheel in an anti-clockwise direction to the backstop will result in the
coarsest milling grade.
Normal Setting: For this setting the hand wheel has to be turned in a clockwise direction so long until
a slight but continuous grinding sound can be heard. When using the normal setting any longer idling
should be avoided. The degree of refinement achieved with this setting results in flour which is
sufficiently fine for all kinds of baking, and at the same time takes the moisture content of the grain
into account.
Finest Setting: In order to get extremely fine flour and provided you have very dry grain you can
reduce this setting by turning the hand-wheel in a clockwise direction as far as the backstop. When
using this setting the sound of the mill-stones grinding against each other can be clearly heard. This
will damage neither the motor nor the mill-stones. Any longer idling operation when using the fine
setting should be avoided.
Important Note!
When the mill is turned off and provided there is no grain between the mill-stones the mill can be
adjusted to any setting.
With a full input funnel a coarser setting can be chosen at any time, however finer settings can
only be slowly set when the mill is in operation. The mill requires sufficient time to process the
grain which is between the mill-stones otherwise the stones will become blocked!
