![background image](http://html1.mh-extra.com/html/salvis/fresh-and-smart-1100/fresh-and-smart-1100_operating-instructions-manual_804165012.webp)
SALVIS AG
CH-4665 Oftringen www.salvis.ch
Salvis Fresh & Smart 1100
Cleaning the filter area
Make sure that the Salvis Fresh & Smart is separated from the mains supply.
To clean the filter area, open the revision panel with a wide slot screwdriver by turning the locking
knobs a fourth of a turn counter-clockwise.
Attention! Risk of injury!
Never open the door of the suction module while the appliance is turned on! Danger of injuries on
the ventilator of the exhaust system. Always disconnect the appliance from the mains supply.
If the cleaning is not carried out as per the following instructions, there is a risk of fire.
Vortex filter (E-Zyclon) (grease filter) / grease trap pan
The vortex filters are located in the right and left side pan. They are lifted upward by the handle on the
top. After that, they can be cleaned in the dishwasher. Please observe the legal requirements for greasy
wastewater, which is generated by cleaning grease filters in the dishwasher. The cleaning intervals
depend on the intensity of use and the degree of grease contamination; however, we recommend daily
cleaning. The same applies to the grease trap pan.
After cleaning Fresh & Smart components or separators in dishwashers, always replace the
water.
After the cleaning and complete drying, the grease filter and the grease trap pan are reinserted. Please
make sure that both components fit properly into the respective recess and that the marking on the the
handle is correctly aligned with the side panel of the Fresh & Smart. The handle on the filter must point
upward.
Ventilator motor unit
The left and right ventilator motor units should only be removed for cleaning if heavily soiled, e.g. if
grease stains are visible on or around the ventilator housing. For this, the respective connection cable
plug must be removed from the receptacle above the ventilator unit. After that, the ventilator can be
pulled from the plastic guide toward the front.
Attention!
You must make sure that no water enters the ventilator motor during the cleaning process. During
a wet cleaning of the interior area, the ventilator motor units must be removed and the blue
receptacle must be capped with a cover.
Page 12
Attention:
Grease filter marking
Attention:
Grease filter marking