Tel: 886.2.2175 2930 Email: [email protected]
50
The oscilloscope will automatically set the waveform to a best display. If you want to further optimize the waveform
display, you may manually adjust the vertical and horizontal controls until the waveform meets your particular
requirement.
Taking Auto Measurements
The oscilloscope can display most signals by automatic measurements. To measure such parameters as the signal
frequency, period, peak-to-peak amplitude, rise time and positive width, follow the steps below.
1.
Push the MEASURE button to see the Measure menu.
2.
Turn the knob V0 to select the first ‘unspecified’ option (marked by red arrow), press V0 or F6 to enter the
submenu.
3.
Select CH1 for the Source option. Then repeatedly push F3 or F4 to select measure items in the Type menu.
Push the back menu to go back to the measure interface. Or turn and push V0 to select a measure item and go
back to the measure interface. The corresponding box under the measure item shows the measurements.
4.
Repeat Step 2 and Step 3. Then select other measure items. Totally 8 measure items can be displayed.
Note: All readouts change with the measured signals.
The figure below shows three measure items as an example. The boxes under them display the measurements in
large fonts.
