Tel: 886.909 602 109 Email: [email protected]
12
2) Install “WinPcap_4_1_3.exe”;
3) Run “anti_uav_radar.exe”;
3.4 Operating Steps
1) Open “anti_uav_radar.exe”, and the “Network Port Selection” window will pop up, select the network port (usually
Ethernet port) connected to the radar;
2) If the radar is working properly, select “System Control / Antenna Power-on Mode” on the main interface as
“Transceiver and Power-on”. Click the “Work” button and the radar will start working normally.
Figure 3.1 Network port selection interface