SAVE THESE INSTRUCTIONS
The Salton Smartsealer
TM
is portable as it can be operated by installing two ‘AA’
Alkaline batteries. Open the Battery Cover by sliding your thumb nail under the
Battery Cover and lift. Install the batteries and snap the Battery Cover back on.
The Salton Smartsealer
TM
has a built in magnetic bottom so it can be stored on the
front of your refrigerator, convenient and ready to use.
ABOUT THE SALTON SMARTSEALER
TM
The Salton Smartsealer
TM
is easy to use. However, it does take a little practice to
get used to the ‘feel of the seal’. So take the time to read the instructions below
and learn about how the Salton Smartsealer
TM
works. You’ll quickly get the ‘feel
of the seal’.
Always use light pressure, just enough pressure to depress the
Heat Pad using the Press Bar. The Salton Smartsealer
TM
is a heat sealer, not a
pressure sealer. So press, don’t squeeze.
HOW TO USE
Install 2 ‘AA’ batteries. Take the heat sealable bag and smooth out the top of the
bags edges evenly to eliminate wrinkles. The insides of the bag’s edges must be
able to touch one another.
No food, dirt, or oil should be between the inner
walls of the bag where the seal is to be made.
Place the open bag to be sealed
into the Salton Smartsealer
TM
. Hold the bag in one hand and the Sealer in the other
hand. Preheat the Smartsealer
TM
by holding down the Press Bar until it engages
the Heat Pad. Hold the Press Bar in this position for 3 seconds, before you start to
move the sealer across the bag to be sealed as this preheats the Heat Wire, then
begin to make the seal. The Salton Smartsealer
TM
only needs to be preheated one
time per use. Use light pressure. Press don’t squeeze.
3
BS1442_BagSealerBooklet_E.indd 3
1442_BagSealerBooklet_E.indd 3
14-03-31 2:16 PM
14-03-31 2:16 P
