3. Close the Lid. Ensure that it snaps tightly into place.
4. Place Kettle on a level, dry, heat resistant surface.
5. Plug into a 120V AC wall outlet.
NOTE:
- Never plug kettle into an electrical outlet when the kettle is empty.
- Direct kettle spout away from cabinets, walls, etc. to prevent
possible steam damage.
6. Depress the On/Off Switch and the indicator light will light up to
indicate that the Kettle is in the boil cycle. Once the water has boiled,
the On/Off Switch will move to the OFF position and the light will
go out.
IMPORTANT: The kettle shuts off automatically only after the
boiling cycle is complete. If the kettle is removed from the base before
the boiling cycle is complete then it will begin to heat as soon as it
is put back on the base. To turn the kettle off before the boiling cycle is
complete, press the On/Off Switch to the OFF position.
7. The Lid should not be opened when the Kettle is hot.
8. If you want to use the Kettle again, allow the thermal safety switch to
cool down for 15 to 20 seconds then depress the On/Off Switch to the
ON position. If the On/Off Switch does not remain in the ON position,
the water is hot enough to use without reheating.
9. Only grip the Kettle by the Handle as all other surfaces will be hot.
10.Return the Kettle to the Base or a heat resistant surface after use.
11.IMPORTANT: If the Kettle is accidently switched on when empty,
the thermostat will automatically cycle on and off to prevent the Kettle
from overheating. If this situation occurs, press the On/Off switch to
the OFF position and unplug the Kettle immediately. Let the Kettle
12.DISCONNECT the Power Cord from the wall outlet when not in use.
CARE AND CLEANING
1. All servicing, other than cleaning, should be performed by an
authorized service representative. See Warranty section.
2. Unplug power cord from wall outlet. Empty out remaining water and
allow Kettle to cool before cleaning.
Exterior
-Use a soft, damp cloth to clean the exterior.
-DO NOT use abrasive cleaners. Dry exterior thoroughly before use.
-DO NOT immerse kettle or power base in water or other liquid.
4
