DO NOT fill past the MAX level indicated on the glass.
Overfilling may cause water to spit out when boiling.
3. Close the Lid. Ensure that it snaps tightly into place.
4. Place Kettle on Base on a flat, level, dry, heat resistant surface.
Ensure that it is correctly engaged on the Base.
5. Plug into a 120V AC wall outlet.
NOTE: Never plug kettle into an electrical outlet when the kettle is
empty.
6. Direct kettle spout away from cabinets, walls, etc. to prevent possible
steam damage.
7. Press the On/Off Switch to the ON (‘I’) position. The blue lights inside
the Kettle will illuminate to indicate that the Kettle is in the boil cycle.
Once the water has boiled, the On/Off Switch will automatically switch
to the OFF (‘O’) position and the blue lights will go out.
IMPORTANT:
a) The kettle shuts off automatically after the boiling cycle is complete.
b) To remove the Kettle from the Base before the boiling cycle is
complete, press the On/Off Switch to the OFF position (‘O’). If the
Switch is not in the OFF position the boil cycle will restart when the
Kettle is replaced on the Base.
8. The Lid should not be opened when the Kettle is hot.
9. If you want to use the Kettle again, allow the thermal safety switch
to cool down for 15 to 20 seconds then depress the On/Off Switch
to the ON (‘I’) position. If the On/Off Switch does not remain in the
ON position, the water is hot enough to use without reheating.
10.Unplug cord from wall outlet before lifting Kettle from Power Base.
Only grip the Kettle by the Handle as all other surfaces will be hot.
11.Return the Kettle to the Base or a heat resistant surface after use.
12.IMPORTANT: If the Kettle is accidently switched on when empty,
the thermostat will automatically cycle on and off to prevent the Kettle
from overheating. If this situation occurs, press the On/Off switch
to the OFF (‘O’) position and unplug the Kettle immediately. Let the
Kettle cool before refilling.
13.It is recommended that the Power Cord be disconnected from the wall
outlet when not in use.
14.DO NOT attempt to connect any other appliance to the Power Base
or tamper with the connector in any way.
CARE AND CLEANING
1. All servicing, other than cleaning, should be performed by an
authorized service representative. See Warranty section.
2. Unplug Kettle from wall outlet. Empty the Kettle and allow it to cool
before cleaning.
4
