Salsco 09074, Operator And Parts Manual

Page: 6 / 35

“O” MANUALS; EGR_QC_0009074 _Manual PW_10.30.2017.doc
6
SERVICE & MAINTENANCE INSTRUCTIONS
1.
Check all grease fittings as listed below on a WEEKLY basis, and grease as necessary. (Add
grease till grease leaks slightly from fitting.)

Bearings on roll housings - Quantity 4

Pivot bearing on main housing - Quantity 2

U-Joint on steering shaft - Quantity 1
2.
After approximately 1 WEEK of use, and then every 2 WEEKS thereafter , check drive
chains - one on each side on roller drive motor. Pivot motor to tighten chain. NOTE: Check
and adjust the tension of both drive motor chains on a regular basis. If chains are not tight,
this could cause severe sprocket wear and possible breakage.
3.
After approximately 1 WEEK of use, and then every 2 WEEKS thereafter , check chains
on steering. Adjust as needed.
4.
Pivot for articulating steering should be tight, with no play, much the same as wheel bearings
on cars.
5.
Keep unit clean . Should rust form on rolls, simply drive the unit on a rough area till rolls are
clean.
6. Battery Maintenance/Charging. SEE MATERIALS/MANUAL PROVIDED BY
TROJAN, ENCLOSED IN THE MANUAL PACKAGE YOU RECEIVED WITH THE
ROLLER.
SAFETY IS A PRIME CONCERN AT SALSCO AND THE SAFETY DECALS ON YOUR MACHINE
ARE A HIGHLY VISIBLE AND CONSTANT REMINDER TO ALL OPERATORS. REPLACEMENT
SAFETY DECALS MAY BE OBTAINED BY CALLING SALSCO @ 1-800-872-5726, OR THE
DEALER IN YOUR AREA.