SALSBURY INDUSTRIES
18300 Central Avenue, Carson, CA 90746-4008
Phone: 1-800-562-5377
Int’l Phone: 323-846-6700
Fax: 1-800-562-5399
Int’l Fax: 323-846-6800
www.lockers.com
engineering
@
lockers.com
Installation instructions are provided as general guidelines. It is advised that a professional installer be consulted. Salsbury Industries assumes no product assembly or installation liability.
Copyright ©
2020
Salsbury Industries. All rights reserved. (Rev. 08, 7/2/15) Page 6 of 8
Locker Options – 77000 Series
Installation Instructions
Anchoring Brackets - One Wide Locker Without Legs
Step 1 – Drill Anchor Hole Locations
Begin the locker installation by placing the locker on its back. Clamp
the appropriate drill template (provided) onto the bottom shelf against
each side wall of the locker. The appropriate drill template is the one
that measures 4” shorter than the locker depth. Drill four (4) 3/16”
diameter holes and four (4) 3/8” diameter holes through the bottom
shelf of the locker in the locations depicted on the templates.
Step 2 – Attach Anchors and Drill Concrete Screw Holes
Remove the templates. Attach two anchoring brackets that are 4”
shorter than depth of locker underneath the bottom shelf of the locker
by placing four (4) #8 x 1/2” long self-drilling screws (provided)
through the four (4) drilled 3/16” diameter holes in the bottom shelf
and through the pre-drilled holes in the anchoring bracket. Set the
locker in place on the concrete base or floor. Drill four (4) 3/16”
diameter holes into the concrete base or floor through the four (4)
drilled 3/8” diameter holes in the bottom shelf and through the slots in
the anchoring brackets. Drill holes at least 2-3/8” deep from the top
surface of the bottom shelf.
Step 3 – Fasten Locker to Concrete
Attach the locker to the concrete base or floor by installing four (4)
1/4” x 2-1/4” long concrete screws (provided) and four (4) 1/4” flat
washers (provided) through the four (4) drilled 3/8” diameter holes in
the bottom shelf, through the slots in the anchoring brackets, and
through the holes drilled into the concrete. The four (4) #8 x 1/2”
long self-drilling screws may be removed after installing the concrete
screws. Installation is now complete.
