SALSBURY INDUSTRIES
18300 Central Avenue, Carson, CA 90746-4008
Phone: 1-800-562-5377
Int’l Phone: 323-846-6700
Fax: 1-800-562-5399
Int’l Fax: 323-846-6800
www.lockers.com
engineering
@
lockers.com
Installation instructions are provided as general guidelines. It is advised that a professional installer be consulted. Salsbury Industries assumes no product assembly or installation liability.
Copyright ©
2020
Salsbury Industries. All rights reserved. (Rev. 08, 7/2/15) Page 3 of 8
Locker Options – 77000 Series
Installation Instructions
Top Fillers – In-Line
In-line top fillers are used to close the tops of gaps between in-line
lockers after vertical front fillers have been installed. The in-line flat
top filler and the in-line sloping hood filler attach in the same manner.
After installing the vertical front filler pieces, place the in-line top
fillers on top of the locker gap as shown in the illustration below.
Attach the fillers with six (6) #8 TEK self-drilling screws through the
holes provided in the in-line top filler.
The in-line top fillers may be cut to special widths for custom
installations. The self-drilling screws will make new holes where the
original holes were cut away.
As an alternate method, the 15” wide top filler may be used to cover
any gap or front filler width smaller than 15” without trimming the top
filler width as shown in the illustration below. Simply use the full
width top filler as is and place it into a position straddling the smaller
opening between locker tops.
