-12-
Fitting guidelines
The ceramic hob is manufactured to work with two-phase alternating
current (400V2N~50Hz). The voltage rating of the ceramic hob
heating elements is 230V. Adapting the ceramic hob to operate with
one-phase current is possible by appropriate bridging in the
connection box according to the connection diagram below. The
connection diagram is also found on the cover of the connection box.
Remember that the connection wire should match the connection
type and the power rating of the ceramic hob.
The connection cable must be secured in a strain-relief clamp.
WARNING!
Remember to connect the safety circuit to the connection box terminal
marked with .The electricity supply for the ceramic hob must have a safety switch
which enables the power to be cut off in case of emergency. The distance between the
working contacts of the safety switch must be at least 3mm. Before connecting the
ceramic hob to the power supply it is important to read the information on the data
plate and the connection diagram.
Wires for each domino hob with touch control models
Model
Adaptive voltage range and wires
The wiring diagram
220-240 1N
～
50-60Hz
380-415 2N
～
50-60Hz
KADO K 1/5
SCC-4602B
H05VV-F 3G2.5 H05VV-F 4G2.5
The cable connections must be in accordance with the diagram located on the bottom of
the hob.
You should use a good quality screwdriver to carefully, fully tighten ALL of the terminal
screws.
If when the hob is first switched on, only two of the zones work, you should recheck that
the terminal screws are all fully tightened. This should be done before contacting the
Customer Care Department.
IMPORTANT: The appliance must NOT be connected to the mains supply by means of a
13A plug and socket.
This appliance must be wired into a 30A double pole switched fused spur outlet, having
3mm contact separation and placed in an easily accessible position adjacent to the
2
1