42
SALICRU
Symptom
Possible cause
Solution
One of the following codes are displayed in the LCD
panel 01, 02, 03, 04, 11, 12, 13, 14,1A, 21, 24, 35, 36,
41, 42 or 43 and the acoustic alarm beeps continously.
An itnernal fault has ocurred. Two possible situations:
1. The load is still supplied, but through the UPS bypass.
2. The load is not supplied.
Contact with the distributor.
The back up time is lower than the expected
Batteries are not fully charged
Charge the batteries for 7 hours at least and then
check their capacity. If the problem persists, contact
with the distributor.
Batteries are damaged
Contact with the distributor to replace the battery.
The
icon and the
TEMP
message blink in the
LCD panel and the acoustic alarm beeps every second.
The fan is blocked or it does not work ; or the UPS
temperature is very high.
Check the fans and contact with the distributor .
Tab. 15.
Troubleshooting guide.
8.3. WARRANTY CONDITIONS.
8.3.1. Warranty terms.
The warranty conditions for this product can be found in our
website, register the product in it. It is recommended to do it
as soon as possible in order to include it in the database of
our Technical Service and Support
(T.S.S.)
. Among other advan-
tages, it will be easier to make any proceeding, in case it was
needed an intervention from
T.S.S.
.
8.3.2. Out of scope of supply.
Our company
is not forced by the warranty in case it is de-
tected that the defect was caused by wrong use, negligence,
not suitable installation and/or checking, reparation by non-au-
thorised personnel, accident, fire, lightning or any other cause
far from the foreseen use. In all these cases, no compensation
will be covered by damaged or injuries.
8.4. TECHNICAL SERVICE NETWORK.
The coverage, both national and international, of the Technical Service
and Support
(T.S.S.)
, can be found in our website.
