Salda RIRS ECO 3.0 Series, Mounting And Installation Instruction

Page: 4 / 60

4 | EN RIRS 1200-5500 V EKO 3.0 v2019.06
Warnings
• Connection of electricity and maintenance of the device should be performed only by a qualified personnel, in accordance with the
manufacturer’s instructions and valid safety requirements.
• In order to reduce the risk during installation and maintenance, suitable protective clothes should be worn.
• Beware of sharp angles while performing installation and maintenance tasks.
• Do not touch heating elements until they haven’t cooled down.
• Some devices are heavy, thus one should be very careful while transporting and installing. Use suitable lifting equipment.
• While connecting electricity to the mains a circuit breaker of suitable size is necessary.
Warning!
• If the device is installed in a cold environment, make sure that all connections and tubes are properly isolated. Intake and discharge air
ducts should be isolated in all cases.
• Openings of the ducts should be covered during transportation and installation.
• Make sure not to damage the heater when connecting the piping of the water heater. For tightening up, use a wrench/spanner.
Before starting the equipment
• make sure, that there are no strange objects inside;
• manually check whether fans are not stuck or blocked;
• if rotary heat exchanger is installed in the device, make sure that it is not stuck or blocked;
• check the grounding;
• make sure that all components and accessories are connected in accordance with the project or provided instructions.
Danger: Fumes
Salda Antifrost
system uses dis-balancing of the air flow and it may cause negative pressure in premises. Great care should be taken
when using at the same time in premises as another heating appliance what depend on the air in premises. Such appliances include
gas, oil, wood or coal-fired boilers and heaters, fireplaces, continuous flow or other water heaters, gas hobs, cookers or ovens which
draw air in from the room and duct exhaust gases out through a chimney or extraction ducting. The heating appliance can be starved
of oxygen, impairing combustion. In exceptional cases harmful gases could be drawn out of the chimney or extraction ducting back
into the room. In this case we strictly recommend to turn off
Salda Antifrost
and use an external preheater for heat exchanger anti-frost
protection (see Salda Antifrost function on the Remote controller manual).
4. DIMENSIONS AND WEIGHT
L
W
H
D*
W1
H1
L1
H
H2*
W2*
H3*
L
W
H
D*
W1
L2*
H2
H1
H4*
H3
L1
d*
W2*
H
W2*
H5*
W3*
W2
W3
L1
L2
L3 L4
D*
W
H1
W1*
L
L5*
H
H2*
L6*
W4*
L3 L1 L2
L4
W
H
W1
L1
L2
H1
L3
L4*
L
d
H2
L5
L3*
RIRS V EKO 3.0
[mm]
1200 1900 2500 3500 5500
L 1500 1500 1600 1930 2115
L1 635 635 200 240 215
L2 230 230 390 410 405
L3 240 240 390 590 850
L4 430 430 390 425 405
L5 - - - - -
L6* - - 250 300 300
H 1150 1150 1300 1355 1400
H1 1190 1190 1350 1405 1450
H2* 70 70 70 140 140
W 855 855 900 1000 1310
W1* - - - - -
W2* 260 260 445 500 650
W3* 315 315 445 500 650