Salamander EZ-Touch Manual Lift Wall Mounts - EZ1/MS85/ML209
501-764 [12.22] page 9 of 9
Safety warnings, contents of the box, tools needed
16”
12”
1x
2x
MOUNT WALL COVER
ATTACH THE SIDE COVERS TO THE
BALANCEBOX®400 USING THE VESA
BRACKET INSTALLATION POINTS AS SHOWN
4x M8
Max 10 mm
Vesa Bracket
EZ1/MA1
1/2”
13mm
Set balance
Never adjust the inner springs!
Balancing: Springs are always fully tightened for safety. Use a drill driver and 10mm socket,
rotate counter clockwise (loosen) evenly. Do three seconds left and three seconds right until the mount is
evenly balanced to support display weightlessly.
It may be necessary to tighten if balanced
point is exceeded.
SALAMANDER WARRANTY
LIMITED WARRANTY FOR COMMERCIAL VIDEO DISPLAY STANDS AND MOUNTS
Salamander warrants against manufacturing defects for two (2) years from the date of purchase. Salamander will repair or replace, at our option, any product
defective in materials or craftsmanship. Batteries are not covered by the warranty.
Full warranty including limitations and warranty claim information may be found at www.salamandercommercial.com
Subject to printing errors and technical amendments.
Lock display with safety lock screws from the bottom
M8 x 10mm (4x)
M4 x 12mm (10x) or
M6 x 12mm (10x) or
M8 x 12mm (10x)
10mm
