Sakai PC600, Operating & Maintenance Instructions

Page: 12 / 28

ー 8 ー
3. Inspection before operation
3.1. Engine
Refer to a separate Engine Operation
Manual for the engine.
3.2. Checking engine oil
①
Remove the oil gauge and wipe off oil
stuck on the gauge with a rag.
②
Push the oil gauge against the oil fill port
without screwing it in to check oil level.
③
Refill oil until it comes to the upper limit
mark when the level is insufficient.
3. Inspection before operation
Oil gauge
Fill port
Drain plug
Maximum oil level
Minimum oil level
(Refill is required)
Be sure to check and refill oil with the engine held level.
Check the oil level again at approx. 3 minutes after it has been refilled.
Do not supply oil more than the specified since over-supply of oil may
result in blowing out of oil and poor output of the engine.
Shortage of oil may cause seizure of the engine.
If an oil other than the specified is used, service life of engine is likely to
be shortened. •
•
•
•
IMPORTANT
Screw in the oil gauge
securely after oil level has
been checked and refilled. •
CAUTION
3.3. Checking oil in the vibrator
Remove the plug out of the fill-drain port
in the vibrator with the machine body held
level and check that the oil is filled up to the
mouth of oil fill-drain port.
If it is found insufficient, supply oil to the
extent that it comes full to mouth of the
port.
Fill drain plug