5.
At the Driver Setup screen, plug in your wireless receiver dongle and click on
Next
.
6.
At the Driver Setup screen, click
Next
to test your controller.
7.
When the Saitek Controller screen appears, try out all your controller’s buttons and controls to
show that it is working properly. When you have finished, click
OK
.
8.
At the Software Setup screen, select
Do not install the SST Programming Software
and click
Next
. The Programming Software can be installed at a later date by following instruction (b)
below
9.
At the Registration screen, select
Check this box to register now
and follow the on-screen
instructions, or you can choose to select this option later.
10. Click on
Finish
to complete the installation.
b) Drivers and programming software for advanced users
1.
Follow points 1 – 7 of the install procedure in A), then at the Software Setup screen, select
Install
the SST Programming Software
and click
Next
.
2.
In the following Software Setup screen, click
Next
and follow the on-screen instructions. At this
point you will be asked to install such features as the Saitek Magic Mouse, HID-compliant mouse,
Saitek Magic Keyboard and HID Keyboard Device (these are what XP calls the various elements
of your Saitek controller). Continue to click on
Next
and
Finish
to accept the installation until the
Registration screen appears.
3. At
the
Registration
screen, select
Check this box to register now
and follow the on-screen
instructions, or do not select this option and register later.
4.
Upon completion of the installation, you have the option to Run Profile Editor, which will give you
a view of the 3D programming environment. If you do not wish to see the Profile Editor at this
point, just uncheck the box and click on
Finish
to complete the installation.
Installation for Users of Windows® 2000
a) Drivers only for typical users
1.
With your computer switched on, close down any programs that are currently running and insert
the Saitek Smart Technology CD into your CD-ROM drive.
2.
When the Introduction Screen appears, click
Install Software
to continue.
3. When
the
Welcome
screen appears, click
Next
to continue. (If the CD does not run
automatically, select
Start
from the Windows® Taskbar, then
Run
and type
D:\Setup.exe
and
click
OK
- where D:\ is letter of your CD-ROM drive).
4.
After reading the Disclaimer, select the
I accept the terms of the Disclaimer
option and click
Next
to continue.
5. At
the
Device Driver Installation
screen, click on
Next
and follow the on-screen instructions.
6.
When prompted, plug your controller’s USB connector into your computer, then click on
Configure
.
7.
When the Controller Properties screen appears, click
Next
to view the
Test
screen.
8.
Now try out all your controller’s buttons and controls to show that it is working properly. When you
have finished, click
OK
.
9.
At the Programming Software screen, select
Typical User
and click
Next
.
10. At the Registration screen, select
Register
and follow the on-screen instructions or select
Register Later
and click
Next
.
11. Click on
Finish
to complete the installation.
b) Drivers and programming software for advanced users
1.
Follow points 1 – 7 of the install procedure in A), then at the Programming Software screen,
select
Advanced User
and click
Next
.
