PRIVA-LITE
12
2.12
– PRIVA-LITE® HOTMELT : Installation in profile
PRIVA-
LITE® SWITCH P IPX4 : 2 cables with Hot Melt
Bottom cable
U PROFILE
SETTING BLOCK
26
26
17
6
6
17
16
16
GLASS CABLE
HOT MELT
HOT MELT
LC FILM
GLASS
GLASS CABLE
LEVELLING PAD
Top cable
SETTING BLOCK
APPROVED SILICONE or
GASKETS (no silicone oil allowed for install !)
APPROVED SILICONE or
GASKETS (no silicone oil allowed for install !)
For bottom cable exit make sure that
the height of the setting blocks is
minimum 8mm to avoid crushing the
HotMelt Molding, the connector and
the cable.
Setting blocks should be at least as
wide as glass
Summary of Contents for PRIVA-LITE
