PRIVA-LITE
2.1 PRIVA-
LITE® GLASS INSTALLATION IN PROFILES
10
Installation is the responsibility of the installer.
PRIVA-LITE
®
must be installed by a professional glazier, according to the rules applicable to
laminated safety glasses.
Only approved
silicone or raw wood
setting block allowed
Important installation rules:
1- Only PRIVA-LITE
®
- approved products may come in
contact with the edge of the glass and be used inside
the profile.
2- Sealing of glass with Silicone or gasket must be
waterproof
– so that no liquids can enter inside profile.
3- PRIVA-LITE
®
may not stand a pressure of more than
10N/cm²
. The profile must be at least 4mm wider than
glass panel (2mm of free space each side)
4- PRIVA-LITE
®
may not be installed in a place where
it could be exposed to heat over 70
°C, or cold
temperature below -20
°C.
Summary of Contents for PRIVA-LITE
