13
The machine can be moved on a flat surface using its wheels. Do not lift this machine using a
crane as no part of the machine is designed to hold up the Trolley’s weight.
5 OPERATING
THE
TROLLEY
5.1 Work Site
Before you start working, please check the following:
Remove from the site anything, which might interfere with the working procedure.
Make sure the site is sufficiently well lit.
Make sure you have a continual adequate view of the working area so you can intervene in
the working process at any time.
Keep other staff out of the area, so you can work safely.
5.2 Cutting method
In this section, you can find instructions to make a straight cut at the desired depth.
5.2.1 Preparing your cut
Before starting the machine,
Read and understand all instructions in this manual and the manual of your High Speed Saw.
For best preformanc DO NOT cut more than 1/2” (12.7mm) per cutting pass with any make or
model of High Speed Saw.
Use all approperate and approved PPE (Personal Protective Equipment) including: Eye,
Hearing, and Head Protection. Insure that the operator is wearing the appropriate work
clothing with no lose items.
Draw a line on the floor over the cutting length.
Make sure you have filled the engine tank with fuel.
Make sure you have mounted the correct blade as recommended by the manufacturer for the
material being cut and for the cutting method wet or dry cutting.
Make sure that the flanges securely hold the Diamond Blade.
Make sure that the blade is not touching the floor before starting.
Bring the handle in a comfortable position.
Roll the machine until the blade is over the line.
5.2.2 Cutting the floor
Properly secure the High Speed Saw to the SPEEDY CART
Verify that ALL hardware is properly tightened and that the machine and SPEEDY CART are
in good operating condition.
Verify that the Throttle control is functioning properly.
