1. Remove the battery door on the back of the sensor by
removing the set screw, as shown in
Figure 1
.
LED
Figure 1
2.
BEFORE
inserting the batteries, locate the dip switches on the
inside cover of the lid of the transmitter.
Figure 2
setting).
Figure 2
3.
Channel Number:
The FT0073 supports up to eight
transmitters. To set each channel number (the default is Channel 1),
change Dip Switches 1, 2 and 3, as referenced in
Table 1
.
4.
Temperature Units of Measure:
To change the transmitter
display units of measure (°F vs. °C), change Dip Switch 4, as referenced
in
Table 1
.
displays all four switches in the OFF position (factory default
-19-
