Saimo 6101, Operating And Service Manual

Page: 49 / 101

6101 6101 6101 6101 Belt Belt Belt Belt Scale Scale Scale Scale Integrator Integrator Integrator Integrator Operating
Operating Operating
Operating and
and and
and Service
Service Service
Service Manual
Manual Manual
Manual
43
1 .9998 7 .9925 13 .9744
2 .9994 8 .9903 14 .9703
3 .9986 9 .9877 15 .9659
4 .9976 10 .9848 16 .9613
5 .9962 11 .9816 17 .9563
Measuring incline angle
m
、
Load cell size
From the belt scale data sheet located in the front of this manual, determine the load cell size
(example: 250.0). record the weight below:
kg
（
load cell size
）
n
、
load cell sensitivity
From the nameplate of load cell, determine the load cell sensitivity in mV/V (example:
3.000mV/V)
Record below:
mV/V
（
load cell sensitivity
）
o
、
load cell resistance
Measue each load cell’s output resistance using digital voltameter (example: 350.00)
Record below:
ohm
（
load cell resistance
）
p
、
Conveyor belt length, measure belt revolution one cycle length to the nearest 1mm with
tape measure.
Record below
：
mm
（
conveyor belt length
）
Press “PAGE DOWN” soft key from the Initial Setup 5 Menu, the sixth page of Initial Setup
Menu is displayed as follows:
The setting value of the speed mode are “Simulated” and “Actual”.
When “Simulated” is selected, the integrator will generate an analog signal for speed input.
2006-3-21 12:00:00 Scale#1
INITIAL SETUP 6
Speed Mode
：
[SIMULATE]
Speed Channel
：
[CHANNEL 1]
Press
↑↓
key, then press ENT!
MAIN PAGE PAGE
MENU DOWN UP