- 18 -
WARNING
We recommend using the button for a few
seconds, just time for this operation, thereby
avoiding too fast clean solvent consumption.
Open and take out the spray gun and accessories. At
this point the aspiration of fumes will always be
operating.
If appropriate you can use the blow gun to evaporate
and totally dry spray gun and accessories.
Once the operation is finished close the lid of the
washing area. Always place the solvent leaber selector
upright.
13. SAFETY DEVICES
14. MAINTENANCE
LEVER AND SWITCH
SELECTION OF WORKING SOLVENT
Upward, horizontal: clean solvent. (not
recycled solvent), can work in automatic
with timer and make a manual pump by
pressing LOWER BUTTON.
The safety devices should always be in an optimal
state and should not be removed.
- Disconnect the compressed air supply in case of
repairs or maintenance.
- Periodically check the integrity and functionality of
safety devices.
- Periodically clean the discharge area, cleaning
area, and control valves.
- Clean and replace the pump suction filter.
- The safety labels must always be clearly visible,
clean and immediately replaced in case of damage.
- It is absolutely forbidden to perform operations with
the equipment when all labels are not clearly visible.
THE EQUIPMENT ALWAYS MUST
BE CONNECTED TO GROUND.
The ordinary maintenance operations must be
carried out only by qualified personnel following the
instructions in this manual. Always cut the air supply
for maintenance or repair.
Ordinary maintenance operations are:
- Clean the working area, grid and discharge.
- Always maintain adequate levels of solvent in each
of the two tanks.
- Check and maintain clean the suction pump filter.
- Maintaining an adequate level cleaning of the
recirculation solvent. Change before accumulating
excess waste and lost washing effectiveness. Once
the solvent substituted, the treatment of this should
follow the applicable regulations.
- Check for proper operation the safety devices and
operating controls.
Do the internal cleaning of the machine weekly.
Internal cleaning of the machine is done by using a
suitable solvent.
Do the cleaning of jets every three weeks. Disassem-
ble and immerse then in a clean solvent for about 1
hour. Wash with clean solvent from about 1 minute to
wash the pipes. Place the injectors clean.
