Sagola 4500xtreme, Instruction Manual

Page: 26 / 56

ENGLISH
It was assembled according to: II 2G Ex ia IIC T4 Gb
In explosion areas 1 and 2 it can be used in temperatures of up to 50
o
.
9. Tips and Needles Kits
SAGOLA S.A. supplies Nozzle Kits and Tip and Needle Kits
of different sizes for a variety of different applications. In
order to replace these, proceed as follows:
With the gun fully depressurised,
remove the air nozzle.
Remove the product regulator
with the
spring
and the
spring
stop and extract the needle
to be replaced. Remove the
tip with the wrench supplied.
Fit the new tip and tighten. Now fit, in this order, the new
needle, the spring and spring stop and the product regulator.
Lastly
, fit the
appropriate
air nozzle.
There are Tip + needle Kits for this model of Ø 1.20, 1.30, 1.30 LX, 1.40 and 1.60
10. Air Nozzle Kits
Air Nozzle Kits LXT TITANIA, LXT AQUA. LXT HVLP and LXT CLEAR
Nozzle Air consumption Pressure
LXT TITANIA 320 litres / minute 2 bar
LXT AQUA 295 litres / minute 2 bar
LXT HVLP 510 litres / minute 2 bar
LXT CLEAR 365 litres / minute 2 bar
11. Start-up
Before each start-up
and especially after cleaning or repairing the unit, a check must be made
that all its elements are securely tightened.
If maintenance or repair work is to be carried out, the gun must be depressurised before work
begins (without air pressure). Should this safety measure not be observed, this may lead to
malfunctions , personal injury and accidents, which may prove to be fatal. SAGOLA S.A. does not
accept any responsibility for the consequences of any non-compliance with these safety
regulations.
Open the spray width and product regulators completely (without removing these from their
housing) by turning these anticlockwise.