Sagola 4500xtreme, Instruction Manual

Page: 32 / 56

ENGLISH
It is important to
check that the lubricant
used does
not contain
components that might impair the spraying quality
(Silicones,
etc.).
16. Health and Safety
In order to carry out maintenance, repairs or cleaning, first disconnect the unit from the compressed
air distribution network.
Never point the unit towards yourself, others or animals The thinners and dilution media used
can cause serious injury.
The location where work is carried out must have sufficient ventilation in accordance with current
legislation and regulations.
Near the unit, only
keep the amount of
product and thinner required
for the work being done at
that time. After work has been completed, thinners and the product to be applied must be
returned to their corresponding storage location.
Keep the working area clean and free of potentially dangerous waste
(thinners, rags, etc. )
While work is in progress, there must not be any source of ignition (naked flames, lighted
cigarettes, etc.) in the working area as these might generate easily flammable gases. Likewise,
the approved protective means must be used (breathing, hearing, etc.) in accordance with the
regulations established in this regard.
If the unit is used in an inadequate manner or its components are altered in any way, severe
material damage may occur and bodily harm may be caused to the operator,
other personnel
and/or animals and may even cause death. SAGOLA S.A. accepts no responsibility in for any
damage caused through the incorrect use of the unit.
THE BATTERY MUST NOT BE REPLACED IN HAZARDOUS AREAS.
See Atex regulations about explosion risk areas.
The battery housing and the pressure measurements sight glass must not be opened in a location
where there is any danger of explosion, (EN 50020 standards. Do not change batteries in a
dangerous location Ex).
Always use approved breathing units in accordance with current Standards and Regulations in
order to protect yourself from emissions produced during application.
Never exceed the maximum air inlet pressure (10 Bar).
As a general, preventive measure we advise you to wear goggles in accordance with the specific
environmental regulations and characteristics for the work centre.
Use gloves when handling the product
(see the manufacturer's recommendations) and clean
the gun.
If, when the gun is in use, the ambient noise level exceeds 90 dB,
the use of approved ear
protectors is recommended.