Sagitter FloorBat Q1, User Manual

Page: 20 / 28

20
To connect the transmitter to a DMX console use a cable conforming to specifications EIA RS-
485: pole twisted, shielded, 120Ohm characteristic impedance and low capacity (SAGITTER
SG DMX3
– SG DMX5).
Do not use microphone cable or other cable with different characteristics than those
specified. Terminations must be made with male / female XLR 3-pin connectors. You must
enter on the last device a terminal plug with a 120Ohm resistance (min1 / 4 W) between
terminals 2 and 3.
IMPORTANT: The cables must not come into contact with each other or with the metal
housing of the connectors. The housing itself must be connected to the shield braid and to
pin 1 of the connectors.
6. - SETUP
6.1 – MENU
1
st
level 2
nd
level 3
rd
level UP/DOWN Notes
Address 001- 512 DMX address
Channel 4CH / 6CH / 11CH DMX channels mode
Dimmer Dimmer
Normal: OFF, speed 1-10
curve 1: OFF, speed 1-10
curve 2: OFF, speed 1-10
Dimmer modes
Frequency
600Hz - 1200Hz - 2000Hz
- 4000Hz - 25KHz
LED frequency
Color
Custom 1
R: 255 G:255
B:255 W:255
A:255 UV:255
000 - 255
Colors manual
adjustment
Program
Program
Color Program
Strobe Color 1… 15
Strobe 0…10
Built-in colors settings
and strobe
Program
Auto Program
Speed Auto 1…5
Speed 0…10
Built-in programs
settings and strobe
Program
Sound Program
Sound
Sound 1… 9
Sound mode and
sensitivity adjustment
(from high to low)
Mast / Slave Master / Slave Master or Slave mode
Screensaving
10S - 60S,
Always ON Switch off display
settings
Informations
Ver: V1.00
Thi sT: 00H00M00S
RunT:
00H00M00S
Temp
Software version
Working hours
Total hours
Temperature
Wireless
ON / OFF
PAIRING (master mode)
CLEAR (slave mode)
On, Off, Pairing and
Clear wireless
IR On / Off IR receiver activation
Default No / Yes Reset to factory settings