Sagi HD70, Operator'S Handbook Manual

Page: 80 / 175

6
CONTROL PANNELS
All the refrigerators are equipped with a general switch (1) and a thermoregulator (2):
“CHILIING/POSITIVE TEMPERATURE
(48)
“FREZING/NEGATIVE TEMPERATURE (49)
“FREZING/NEGATIVE TEMPERATURE (49a)
STARTING AND WORKING
To start operation, follow this procedure:
- Insert the plug into the current tap; (50)
- position the line switch on ON; (51)
- push the main switch (
1 ); the green indicator turns on;
Now set the operating temperature with the thermoregulator (
2 ).
Check on the thermoregulator display (
2 ) that the internal temperature of the counter corresponds to the set
value.
WORKING SETPOINT AND CONFIGURATION PARAMETERS
“POSITIVE TEMPERATURE” (48)
Setting the working setpoint
•
press LED will flash
•
press or , within 15 seconds to change the temperature value.
•
after changing the value, confirm by pressing , or avoiding any operation for 15 seconds.
You also can modify the working setpoint through parameter
SP .
Working setpoints
LABEL MIN. MAS. U.M. DEF. WORKING SETPOINTS
r1 r2 °C/°F (1) 0 working setpoint
Setting configuration parameters
To gain access the procedure:
•
make sure no procedure is running
•
press and 4 s: the display will show “ PA ”
•
press
•
press or in 15 s to set “ -19 ”
•
press or do not operate 15 s
•
press and 4 s: the display will show “ SP ”
To select a parameter:
•
press or
To modify a parameter:
•
press
•
press or in 15 s
•
press or do not operate 15 s.
To quit the procedure:
POS DESCRIZIONE
1
MAIN SWITCH
2
THERMOREGULATOR