1-Free Sagemcom - Modification with the authorization of the management concerned
– This docu-
ment and the information it contains is the property of Sagemcom
UM User Manual (EN) rev. 3.2
Page 8
3000499643-R11-000-01
2.
PREAMBLE
General overview
The product is a water meter intended to be installed to count volume of water passing through. It of-
fers measurements of different flow parameters, a CAT-
M1 ™ radio with an optional external antenna
connector, an optional BLE interface, an optional optical infrared interface and a push button.
The measurement data can be displayed on the front panel LCD or are also remotely available via op-
tical, BLE or the radio.
The meter pipe can be installed for metrology in whatever direction.The meter will not measure flow
when an empty pipe condition is experienced. An empty pipe is defined as a condition when the flow
sensors are not fully submerged.
The unit of measure and resolution are factory programmed. Options include gallons, cubic feet and
cubic meters.
FCC
Federal Communications Commission (FCC) Statements
WARNING TO USERS IN THE UNITED STATES
Federal Communication Commission Interference
Statement 47 CFR Section 15.105(b)
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is encouraged to try to correct the interfer-
ence by one of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This device UM20-CM4-13 complies with Part 15 of the FCC Rules. Operation is subject to the follow-
ing two conditions: (1) This device may not cause harmful interference, and (2) this device must ac-
cept any interference received, including interference that may cause undesired operation.
NO UNAUTHORIZED MODIFICATIONS
47 CFR Section 15.21
