Page 2 of 31
TAINY GMOD-T1
File 3159AD001_V1_3_050701.doc
File saved
01.07.2005
File printed
01.07.2005
State Freigabe
Autor Katharina
Bora
!
Safety precautions
General
: The product TAINY GMOD-T1 complies with European standard EN60950, 05.2003, Safety
of Information Technology Equipment.
Read the installation instructions carefully before using the device.
Keep the device away from children, especially small children.
The device must not be installed or operated outdoors or at damp locations.
Do not operate the device if the connecting leads or the device itself are damaged.
External power supply
: Use only an external power supply which also complies with EN60950. The
output voltage of the external power supply must not exceed 30VDC. The output of the external power
supply must be short-circuit proof.
When connecting to a battery or accumulator, make sure that an all-pole circuit-breaker (main battery
switch) with sufficient selectivity and a fuse with sufficient selectivity are provided between the device
and the battery or accumulator.
Please pay regard to section
Technical Data
of the installation manual, as well as the installation and
utilisation regulations of the respective manufacturers of the power supply, the battery or the
accumulator.
SIM card
: To install the SIM card the device must be opened. Before opening the device, disconnect
it from the supply voltage. Static charges can damage the device when it is open. Discharge the
electric static of your body before opening the device. To do so, touch an earthed surface, e.g. the
metal casing of the switch cabinet. Please pay regard to section
Inserting or changing the SIM card
of
the installation manual.
Handling cables
: Never pull a cable connector out of a socket by its cable, but pull on the connector
itself. Cable connectors with screw fasteners (D-Sub) must always be screwed on tightly. Do not lay
the cable over sharp corners and edges without edge protection. If necessary, provide sufficient strain
relief for the cables.
For safety reasons, make sure that the bending radius of the cables is observed.
Failure to observe the bending radius of the antenna cable results in the deterioration of the system's
transmission and reception properties. The minimum bending radius static must not fall below 5 times
the cable diameter and dynamic below 15 times the cable diameter.
Radio device
: Never use the device in places where the operation of radio devices is prohibited. The
device contains a radio transmitter which could in certain circumstances impair the functionality of
electronic medical devices such as hearing aids or pacemakers. You can obtain advice from your
physician or the manufacturer of such devices. To prevent data carriers from being demagnetised, do
not keep disks, credit cards or other magnetic data carriers near the device.
Installing antennas
: The emission limits as recommended by the Commission on Radiological
Protection (13/14 September 2001) must be observed.
Installing an external antenna
: When installing an antenna outdoors it is essential that the antenna
is fitted correctly by a qualified person. Lightning Protection Standard VDE V 0185 Sections 1 to 4, in
its current version, and further standards must be observed.
Lightning protection category for buildings
: For outdoor installation, the antenna may be fitted only
within the lightning protection zones O/E or 1. These lightning protection zones are prescribed by the
lightning protection spherical radius.
The EMV lightning protection zone concept
is to be observed. To avoid large induction loops a
lightning protection equipotential bonding is to be used. If the antenna or antenna cable is installed
near to the lightning protection system, the minimum distances to the lightning protection system must
be observed. If this is not possible, insulated installation as described in VDE V 0185 Sections 1 to 4,
in its current version, is essential.
